enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   Serrated flange nuts. A flange nut is a nut that has a wide flange at one end that acts as an integrated washer.This serves to distribute the pressure of the nut over the part being secured, reducing the chance of damage to the part and making it less likely to loosen as a result of an uneven fastening surface.

3. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Acorn nut (cap nut) Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut

4. Serrated face nut - Wikipedia

   en.wikipedia.org/wiki/Serrated_face_nut

   Serrated face nut. A serrated face nut is a locknut with ridges on the face of the nut that bite into the surface it is tightened against. The serrations are angled such that they keep the nut from rotating in the direction that would loosen the nut. Due to the serrations they cannot be used with a washer or on surfaces that cannot be scratched ...

5. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   spanner (wrench) size and thread diameter of a hex nut. Width across flats is the distance between two parallel surfaces on the head of a screw or bolt, or a nut, mostly for torque transmission by positive locking. The term width across flats (AF) is used for the following forms: 2-socket = round material with two surfaces

6. Serrated flange nut - Wikipedia

   en.wikipedia.org/?title=Serrated_flange_nut&...

   Retrieved from "https://en.wikipedia.org/w/index.php?title=Serrated_flange_nut&oldid=352998244"This page was last edited on 30 March 2010, at 18:31

7. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...