enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cable jetting - Wikipedia

   en.wikipedia.org/wiki/Cable_Jetting

   Cable jetting is the process of blowing a cable through a duct while simultaneously pushing the cable into the duct. Compressed air is injected at the duct inlet and flows through the duct and along the cable at high speed. (Preferably, no suction pig is used at the cable head.) The high speed air propels the cable due to drag forces and ...

3. Directional boring - Wikipedia

   en.wikipedia.org/wiki/Directional_boring

   Directional boring machine. Directional boring, also referred to as horizontal directional drilling (HDD), is a minimal impact trenchless method of installing underground utilities such as pipe, conduit, or cables in a relatively shallow arc or radius along a prescribed underground path using a surface-launched drilling rig.

4. Come-along - Wikipedia

   en.wikipedia.org/wiki/Come-along

   A similar heavy-duty unit with a combination chain and cable became available in 1935 that was used by railroads, but lacked the success of the cable-only type units. [1] A similar tool to a come-along is a cable puller, which does not have a drum and ratchet but directly grips the cable, allowing unlimited lengths of wire rope to be used.

5. Underground pneumatic boring - Wikipedia

   en.wikipedia.org/wiki/Underground_pneumatic_boring

   Underground pneumatic drills can be used in the installation of public utilities like power lines, gas lines, phone cables, and cable television. It can also be used to install residential lawn irrigation systems. Boring is especially useful when it is difficult or cost-prohibitive to plow or trench.

6. Underground power line - Wikipedia

   en.wikipedia.org/wiki/Underground_power_line

   An underground power line provides electrical power with underground cables. Compared to overhead power lines , underground lines have lower risk of starting a wildfire and reduce the risk of the electrical supply being interrupted by outages during high winds, thunderstorms or heavy snow or ice storms.

7. Microducts - Wikipedia

   en.wikipedia.org/wiki/Microducts

   A common cable installation technique for fiber cables remains cable pulling. After the duct is placed, a high-strength pull line is blown into the duct (if one has not already been pre-installed by the duct manufacturer). The pull line is attached to one end of the cable and is used to pull the cable through the duct.