Search results
Results from the WOW.Com Content Network
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
In the framing of a deck or floor system, a rim joist is attached perpendicular to the joists, and provides lateral support for the ends of the joists while capping off the end of the floor or deck system. Rim joists are not to be confused with end joists, which are the first and last joists at the ends of a row of joists that make up a floor ...
Unusual sill framing in a granary of half-timber construction. Long tenons project through the sill plate. Timber sills can span gaps in a foundation. A sill plate or sole plate in construction and architecture is the bottom horizontal member of a wall or building to which vertical members are attached. The word "plate" is typically omitted in ...
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...
Traditional timber frame bents were one component of a braced frame in timber framing. Historically, mortise and tenon joints were used to joint bents to posts and beams due to the unavailability of nails. [4] Bents are generally pre-assembled, either at the timber framing company's shop or at the construction site.
The main function of an OWSJ is to provide direct support for roof or floor deck and to transfer the load imposed on the deck to the structural frame i.e. beam and column. In order to accurately design an OWSJ, engineers consider the joist span between bearing points, joist spacing, slope, live loads , dead loads , collateral loads, seismic ...
A double jettied timber-framed building. The ends of the multiple cantilevered joists supporting the upper floors can easily be seen.. Jettying (jetty, jutty, from Old French getee, jette) [1] is a building technique used in medieval timber-frame buildings in which an upper floor projects beyond the dimensions of the floor below.