Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
Two video matrix units in a rack. A video router, also known as a video matrix switch or SDI router, is an electronic switch designed to route video signals from multiple input sources such as cameras, VT/DDR, computers and DVD players, to one or more display devices, such as monitors, projectors, and TVs.
Alternative to RCA for professional video electronics. Protocols: Serial digital interface (SDI) and HD-SDI. CoaXPress; 75 Ω for video signal (SDI and CoaXPress) on, for example, RG59 and RG6. 50 Ω for data link, like Ethernet on RG58. 93 Ω on RG62. 50 Ω (white/bottom row) and 75 Ω C connectors (red/top row) C connector (Concelman connector)
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
Several generic digital data connection standards are designed to carry audio/video data along with other data and power: USB was designed as a single connector to support all needs, including any generic data, audio/video, power, and more; DisplayLink is its most successful Audio+Video protocol. Until the 3.0 revision, very low data rates ...
If an SDTI stream is viewed using a standard SDI device, then the raw data can be seen as a small strip along the left-hand side (usually in purple). The DVCAM SDTI has video data at the top, control data in the middle (Timecode, etc.) and audio at the bottom just like it is organised on the tape.
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.
A GMSL serializer receives video from a standard digital video interface such as HDMI, DisplayPort, Camera Serial Interface (CSI-2) or Display Serial Interface (DSI) and can transmit it over a cable of up to 15 m in length. [5] The data is received by a GMSL deserializer that can output it on another standard digital video interface.