Search results
Results from the WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
SFM is a combination of diameter and the velocity (RPM) of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.
The spindle motor speed can use one of two types of disk rotation methods: 1) constant linear velocity (CLV), used mainly in optical storage, varies the rotational speed of the optical disc depending upon the position of the head, and 2) constant angular velocity (CAV), used in HDDs, standard FDDs, a few optical disc systems, and vinyl audio ...
1 / 60 Hz = 0.01 6 Hz. SI base units. 0.01 6 s −1. Revolutions per minute (abbreviated rpm, RPM, rev/min, r/min, or r⋅min−1) is a unit of rotational speed (or rotational frequency) for rotating machines. One revolution per minute is equivalent to 1 60 hertz.
Critical speed. In solid mechanics, in the field of rotordynamics, the critical speed is the theoretical angular velocity that excites the natural frequency of a rotating object, such as a shaft, propeller, leadscrew, or gear. As the speed of rotation approaches the object's natural frequency, the object begins to resonate, which dramatically ...
DN factor. DN factor, also called DN Value, is a number that is used to determine the correct base oil viscosity for the lubrication of various types of bearings. [1][2][3][4][5] It can also be used to determine if a bearing is the correct choice for use in a given application. [3] It is a product of bearing diameter (D) and speed (N). [1][2]
The controller is then responsible for driving and monitoring the various positioning components which move the milling head and gantry and control the spindle speed. Spindle speeds can range from 30,000 RPM to 100,000 RPM depending on the milling system, with higher spindle speeds equating to better accuracy, in a nutshell the smaller the tool ...
A ring spinning machine in the 1920s. Ring spinning is a spindle -based method of spinning fibres, such as cotton, flax or wool, to make a yarn. The ring frame developed from the throstle frame, which in its turn was a descendant of Arkwright 's water frame. Ring spinning is a continuous process, unlike mule spinning which uses an intermittent ...