Search results
Results from the WOW.Com Content Network
Start by tying a clove hitch around the spar or pole. Then make an additional turn around with the working end, in the same direction as the turns forming the clove hitch. Now, tuck the working end under the standing part of the original clove hitch. Pull up tight to complete the hitch.
Zeppelin bend forming a loop: the four stages of the method starting with a "clover leaf" or flattened overhand knot; Red line: ends of the overhand knot, Green line: ends of the underhand. Another method of remembering this knot is to visualize a "69". To tie the knot with this method, follow the steps below: Make a "6" with one line (rope) end.
The reef knot can capsize if one of its standing ends is pulled.. A knot that has capsized or spilled has deformed into a different structure. Although capsizing is sometimes the result of incorrect tying or misuse, it can also be done purposefully in certain cases to strengthen the knot (see the carrick bend [4]) or to untie a seized knot which would otherwise be difficult to release (see ...
First called "constrictor knot" in Clifford Ashley's 1944 work The Ashley Book of Knots, this knot likely dates back much further. [5] Although Ashley seemed to imply that he had invented the constrictor knot over 25 years before publishing The Ashley Book of Knots, [1] research indicates that he was not its only originator, but his Book of Knots does seem to be the source of subsequent ...
This knot is particularly useful where the length of the running end needs to be adjustable, since feeding in rope from either direction will loosen the knot to be tightened at a new position. With certain types of cord, the clove hitch can slip when loaded. [2] In modern climbing rope, the clove hitch will slip to a point, and then stop ...
Knot board [] on Elbe 1 (ship, 1965). A knot is an intentional complication in cordage [1] which may be practical or decorative, or both. Practical knots are classified by function, including hitches, bends, loop knots, and splices: a hitch fastens a rope to another object; a bend fastens two ends of a rope to each another; a loop knot is any knot creating a loop; and splice denotes any multi ...
The bowline (/ ˈ b oʊ l ɪ n / or / ˈ b oʊ l aɪ n /) [2] is an ancient and simple knot used to form a fixed loop at the end of a rope. It has the virtues of being both easy to tie and untie; most notably, it is easy to untie after being subjected to a load.
As mentioned earlier, this knot can replace the figure-eight knot when tying into a climbing harness by tying a regular bowline knot and then re-threading it, such as is done with a figure eight knot. However, it is critical to use a strong backup knot with plenty of tail beyond the knot, as the knot may untie during long climbs. The advantage ...