Search results
Results from the WOW.Com Content Network
There were many ratios offered over the lifetime of the AMC 20. [1] Letter codes were stamped on the axle to indicate installed gears. AMC changed or reused letter codes during the axle's long life. There are other gear ratios available in the aftermarket.
The ID number C300-15 is stamped on the case. The output for the front drive shaft is on the right side and the rear output in line with the input. Low range is 2.62:1. One common modification of the Dana 300 is to add oil paddles to the main shaft to prevent oil starvation of the rear bearing. The Dana 300 was used in Jeep CJs from 1980 to 1986.
When in "4-Low" mode the front and rear axles are locked together and power is sent to all four-wheels through a 2.92:1 gear reduction in the power transfer unit; providing a crawl ratio of 56:1 for four cylinder Jeep Cherokees and a 47.8:1 crawl ratio for six-cylinder Cherokees. All Cherokees with this system have a raised ride height of one inch.
Dana 61 axle tag showing 3.73:1 ratio [1] The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a ...
1984-1997 Jeep Wagoneer; 1984-2001 Jeep Cherokee; 1993-2004 Jeep Grand Cherokee; 1986-1992 Jeep Comanche; 1987-1995 Jeep YJ Wrangler Note: there was no 96 model. 1997-2006 Jeep TJ Wrangler *option Dana 44 rear and Rubicon's had Dana 44's; 2007 only some early Jeep JK 2 door Wranglers had Dana 35 non c-clip axles. 2001-2007 Jeep Liberty; Dodge ...
This axle is referred to as a Dana 44 ICA or Dana 44 IRS. All 1980–1982 Chevrolet Corvette C3 and manual transmission equipped 1985–1996 Chevrolet Corvette C4 had this axle. The 2005–06 Pontiac GTO, The Dodge Viper has always used a Dana 44 IRS setup. The majority of Corvette and Viper Dana 44 IRS set ups use a limited slip differential.
The final drive ratios of the CJ-7 were different for each type of engine: the 145 cu in (2.4 L) diesel was mated to the 4.10 ratio axle (in both Renegade and Laredo), while the 258 cubic-inch straight six and 150 cubic-inch four-cylinder used 3.73 and AMC V8 304-powered models (produced 1976–1981, which became part of the Golden Eagle ...
The Jeep Truck was available with only one transmission, the Borg-Warner T-90 three-speed manual, with synchromeshed second and third gears. A Spicer/Dana 18 transfer case was used on four-wheel drive models. The heavy duty Timken 51540 was used in the early years of production, later being replaced by the Dana 53. The front axle was a Dana 25