Search results
Results from the WOW.Com Content Network
Energy per reaction is the energy released in each fusion reaction; This equation is typically averaged over a population of ions which has a normal distribution. The result is the amount of energy being created by the plasma at any instant in time. Lawson then estimated [5] the radiation losses using the following equation:
A fusion energy gain factor, usually expressed with the symbol Q, is the ratio of fusion power produced in a nuclear fusion reactor to the power required to maintain the plasma in steady state. The condition of Q = 1, when the power being released by the fusion reactions is equal to the required heating power, is referred to as breakeven , or ...
Quantity (common name/s) (Common) symbol/s Defining equation SI unit Dimension Temperature gradient: No standard symbol K⋅m −1: ΘL −1: Thermal conduction rate, thermal current, thermal/heat flux, thermal power transfer
This corresponds to a total scientific energy gain of 0.7 and a capsule energy gain of 6. [14] While the experiment fell short of ignition as defined by the National Academy of Sciences – a total energy gain greater than one – most people working in the field viewed the experiment as the demonstration of ignition as defined by the Lawson ...
Fusion energy gain factor: 2022: 1.54: NIF [286] Discharge time (field reversed configuration) 2016: 3 × 10 −1 s: Princeton Field Reversed Configuration [307] Fusion was not observed. Discharge time is not confinement time. Discharge time (stellarator) 2019 >1 × 10 2 s: Wendelstein 7-X [308] [309] Discharge time (tokamak) 2022 >1 × 10 3 s ...
Sol-air temperature (T sol-air) is a variable used to calculate cooling load of a building and determine the total heat gain through exterior surfaces. It is an improvement over: It is an improvement over:
Hence, the main functional application of Gibbs energy from a thermodynamic database is its change in value during the formation of a compound from the standard-state elements, or for any standard chemical reaction (ΔG° form or ΔG° rx). The SI units of Gibbs energy are the same as for enthalpy (J/mol).
In 1997, JET set the record of 16 megawatts of transient fusion power with a gain factor of Q = 0.62 and 4 megawatts steady state fusion power with Q = 0.18 for 4 seconds. [3] In 2021, JET sustained Q = 0.33 for 5 seconds and produced 59 megajoules of energy, beating the record 21.7 megajoules released in 1997 over around 4 seconds. [4]