Search results
Results from the WOW.Com Content Network
A wall panel is single piece of material, usually flat and cut into a rectangular shape, that serves as the visible and exposed covering for a wall. Wall panels are functional as well as decorative, providing insulation and soundproofing , combined with uniformity of appearance, along with some measure of durability or ease of replaceability.
The panels were not confined to just the walls of a room but were used to decorate doors, frames, cupboards, and shelves also. It was standard for mirrors to be installed and framed by the carved boiseries, especially above the mantelpiece of a fireplace. Paintings were also installed within boiseries, above doorways or set into central panels. [7]
As a building material, stucco is a durable, attractive, and weather-resistant wall covering. It was traditionally used as both an interior and exterior finish applied in one or two thin layers directly over a solid masonry, brick, or stone surface. The finish coat usually contained an integral color and was typically textured for appearance.
A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.
Typical Baltimore formstone-faced rowhouses Example of Formstone style masonry from Richmond District in San Francisco. Formstone is a type of stucco [1] commonly applied to brick rowhouses in many East Coast urban areas in the United States, although it is most strongly associated with Baltimore.
Marbleizing (also spelt marbleising [1]) or faux marbling is the preparation and finishing of a surface to imitate the appearance of polished marble.It is typically used in buildings where the cost or weight of genuine marble would be prohibitive.
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Glass block wall in Chicago. Glass blocks can provide light and serve as a decorative addition to an architectural structure, but hollow glass blocks are non load-bearing unless stated otherwise. Hollow glass wall blocks are manufactured as two separate halves and, while the glass is still molten, the two pieces are pressed together and annealed.