Search results
Results from the WOW.Com Content Network
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
Path MTU Discovery (PMTUD) is a standardized technique in computer networking for determining the maximum transmission unit (MTU) size on the network path between two Internet Protocol (IP) hosts, usually with the goal of avoiding IP fragmentation. PMTUD was originally intended for routers in Internet Protocol Version 4 (IPv4). [1]
An IPv4 or IPv6 address query for the name localhost must always resolve to the respective loopback address. Applications may resolve the name to a loopback address themselves, or pass it to the local name resolver mechanisms. When a name resolver receives an address (A or AAAA) query for localhost, it should return the appropriate loopback ...
The name localhost is a commonly defined hostname for the loopback interface in most TCP/IP systems, resolving to the IP addresses 127.0.0.1 in IPv4 and ::1 for IPv6.As a top-level domain, the name has traditionally been defined statically in host DNS implementations with address records (A and AAAA) pointing to the same loopback addresses.
An ephemeral port is a communications endpoint of a transport layer protocol of the Internet protocol suite that is used for only a short period of time for the duration of a communication session. Such short-lived ports are allocated automatically within a predefined range of port numbers by the IP stack software of a computer operating system.
The term port number was not yet in use. It was preceded by the use of the term socket number in the early development stages of the network. A socket number for a remote host was a 40-bit quantity. [4] The first 32 bits were similar to today's IPv4 address, but at the time the most-significant 8 bits were the host number.
The message header is completed with the operation code for request (1) and reply (2). The payload of the packet consists of four addresses, the hardware and protocol address of the sender and receiver hosts. The principal packet structure of ARP packets is shown in the following table which illustrates the case of IPv4 networks running on ...