Search results
Results from the WOW.Com Content Network
Surface-mount technology (SMT), originally called planar mounting, [1] is a method in which the electrical components are mounted directly onto the surface of a printed circuit board (PCB). [2] An electrical component mounted in this manner is referred to as a surface-mount device ( SMD ).
A grid array of solder balls on a printed circuit board after removal of an integrated circuit chip. Cross-cut section of BGA mounted circuit. A ball grid array (BGA) is a type of surface-mount packaging (a chip carrier) used for integrated circuits. BGA packages are used to permanently mount devices such as microprocessors.
Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...
Dip soldering is used for both through-hole printed circuit assemblies, and surface mount. It is one of the cheapest methods to solder and is extensively used in the small scale industries of developing countries . Dip soldering is a manual equivalent of automated wave soldering. The apparatus required is just a small tank containing molten solder.
When potting a circuit board that uses surface-mount technology, low glass transition temperature (T g) potting compounds such as polyurethane or silicone may be used. High T g potting compounds may break solder bonds through solder fatigue by hardening at a higher temperature because the coating then shrinks as a rigid solid over a larger part ...
Flat no-leads, also known as micro leadframe (MLF) and SON (small-outline no leads), is a surface-mount technology, one of several package technologies that connect ICs to the surfaces of PCBs without through-holes. Flat no-lead is a near chip scale plastic encapsulated package made with a planar copper lead frame substrate.
During automated SMT pick-and-place, this happens mostly if the mechanical pressure of the SMD placer nozzle is too low. If the MELF components are placed into the solder paste with enough pressure, then this problem can be minimized. Care must be taken with glass diodes which are less mechanically robust than resistors and other MELF components.
Sensors installed to a fixture to check selective solder machine parameters Selective soldering machine. Selective soldering is the process of selectively soldering components to printed circuit boards and molded modules that could be damaged by the heat of a reflow oven or wave soldering in a traditional surface-mount technology (SMT) or through-hole technology assembly processes.