Search results
Results from the WOW.Com Content Network
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale. In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
Two wooden yardsticks with brass ends, in inches and division of yard for half, quarter, eighth and sixteenth A folding metre-stick carpenter's ruler with millimetre divisions and numbers in centimetres. Fully extended it measures 2 metres. In countries in which the metric system is used, the scale typically contains only a metric scale.
Nothing inherent in nature dictates that an inch has to be a certain length, nor that a mile is a better measure of distance than a kilometre. Over the course of human history, however, first for convenience and then for necessity, standards of measurement evolved so that communities would have certain common benchmarks.
Many US tapes also have special markings every 16 inches (406 mm), which is a US standard interval for studs in construction: three spaces of 16 inches make exactly 4 feet (1,219 mm) which is the US commercial width of a sheet of plywood, gyproc or particle board. A dual scale inch/centimeter tape measure.
1:24 scale model of the Ford GT, at rear, behind 1:32 and nominal HO models, illustrate the traditional slot car scales.. 1:24 scale is a size for automobile models such as injection-molded plastic model kits or metal die-cast toys, which are built and collected by both children and adults.