enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Belden Incorporated - Wikipedia

   en.wikipedia.org/wiki/Belden_Incorporated

   Belden is a global, publicly traded company specializing in the design, manufacture, and distribution of end-to-end networking, security and connectivity products. [1] The company serves the Industrial Automation Solutions, Smart Buildings and Broadband & 5G markets.

3. Coaxial cable - Wikipedia

   en.wikipedia.org/wiki/Coaxial_cable

   Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.

4. RG-58 - Wikipedia

   en.wikipedia.org/wiki/RG-58

   RG-58/U is a type of coaxial cable often used for low-power signal and RF connections. The cable has a characteristic impedance of either 50 or 52 Ω. "RG" was originally a unit indicator for bulk RF cable in the U.S. military's Joint Electronics Type Designation System. There are several versions covering the differences in core material ...

5. BNC connector - Wikipedia

   en.wikipedia.org/wiki/BNC_connector

   Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [9] using a special power or manual tool. [10] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used ...

6. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

7. Electrical termination - Wikipedia

   en.wikipedia.org/wiki/Electrical_termination

   A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.