Search results
Results from the WOW.Com Content Network
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters . These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP ) or is not 8-bit clean .
During the encoding of a frame, the input data bits (D) are repeated and distributed to a set of constituent encoders. The constituent encoders are typically accumulators and each accumulator is used to generate a parity symbol. A single copy of the original data (S 0,K-1) is transmitted with the parity bits (P) to make up the code symbols. The ...
A Data Matrix on a Mini PCI card, encoding the serial number 15C06E115AZC72983004. The most popular application for Data Matrix is marking small items, due to the code's ability to encode fifty characters in a symbol that is readable at 2 or 3 mm 2 (0.003 or 0.005 sq in) and the fact that the code can be read with only a 20% contrast ratio. [1]
In information theory, data compression, source coding, [1] or bit-rate reduction is the process of encoding information using fewer bits than the original representation. [2] Any particular compression is either lossy or lossless .
ARINC 429 is a data transfer standard for aircraft avionics. It uses a self-clocking, self-synchronizing data bus protocol (Tx and Rx are on separate ports). The physical connection wires are twisted pairs carrying balanced differential signaling. Data words are 32 bits in length and most messages consist of a single data word.
To convolutionally encode data, start with k memory registers, each holding one input bit.Unless otherwise specified, all memory registers start with a value of 0. The encoder has n modulo-2 adders (a modulo 2 adder can be implemented with a single Boolean XOR gate, where the logic is: 0+0 = 0, 0+1 = 1, 1+0 = 1, 1+1 = 0), and n generator polynomials — one for each adder (see figure below).
In coding theory, Hamming(7,4) is a linear error-correcting code that encodes four bits of data into seven bits by adding three parity bits. It is a member of a larger family of Hamming codes , but the term Hamming code often refers to this specific code that Richard W. Hamming introduced in 1950.
Turbo coding is an iterated soft-decoding scheme that combines two or more relatively simple convolutional codes and an interleaver to produce a block code that can perform to within a fraction of a decibel of the Shannon limit.