Search results
Results from the WOW.Com Content Network
A tower crane is usually assembled by a telescopic jib (mobile) crane of greater reach (also see "self-erecting crane" below) and in the case of tower cranes that have risen while constructing very tall skyscrapers, a smaller crane (or derrick) will often be lifted to the roof of the completed tower to dismantle the tower crane afterwards ...
Crane The tower crane (see picture) is a modern form of balance crane that is fixed to the ground. A horizontal boom is balanced asymmetrically across the top of the tower. The long arm carries the lifting gear. The short arm is called the machinery arm; this holds the motors and electronics to operate the crane, as well as the concrete ...
Dynamic loads considered in lifting design are accounted for in two stages; suction to the casting bed on the initial lift and then the dynamic loads induced from crane vibration. These crane impact loads must be accounted for during transportation in the yard and on-site, and the coefficient increases from an overhead gantry crane through to a ...
National Lift Tower: Express Lift Company Northampton, England: 418 ft (127 m) 1982 Became the tallest elevator test tower upon completion in 1982 16 Canny Test Tower [17] Canny Elevator Chengdu, China: 394 ft (120 m) 2015 17 Research Centre Test Tower [18] Otis: Bristol, Connecticut, United States 384 ft (117 m) 1987 Basarab Tower (former)
The only lift-testing tower in Britain, and one of only two in Europe, it was granted Grade II listed building status on 30 October 1997, making it the youngest listed building in the UK at the time. The building's small, obround shaped windows were a design motif of the Express Lift Company, whose lift control panels featured control buttons ...
Lifting equipment, also known as lifting gear, is a general term for any equipment that can be used to lift and lower loads. [1] Types of lifting equipment include heavy machinery such as the patient lift , overhead cranes , forklifts , jacks , building cradles, and passenger lifts, and can also include smaller accessories such as chains ...
A jib or jib arm is the horizontal or near-horizontal beam used in many types of crane to support the load clear of the main support. [1] [2] An archaic spelling is gib. [3] Usually jib arms are attached to a vertical mast or tower or sometimes to an inclined boom.
The operator's cabin hosts a display showing the tower crane's position, movement and operating area. Where the tower crane’s operating area overlaps with other cranes or prohibited zones these are also displayed. The system alerts the operator when the crane is approaching a prohibited area or another crane. [9]