Search results
Results from the WOW.Com Content Network
It was intended for coax style cable up to 0.281 inches (7.1 mm) outside diameter. Attachment is made with a 5/8-27 threaded ring that can be unthreaded over the body of the connector body allowing the female connector to become a male connector. Wire connection was via solder.
† Although the mic input is usually mono, the input is still a TRS phone socket. Many mono 'computer' mics are fitted with TRS plugs. The tip is for the MIC and the ring is for power (to power an electret-condenser style MIC). There are exceptions to the above: Hosa cables use grey and orange for left and right analogue channels.
3.5 mm TRRS connector (male) 3.5 mm (1 ⁄ 8 in) TRRS and TRS connector: Analog camcorders commonly use a 3.5 mm four-contact TRRS connector to carry composite video and stereo audio. Jack appears identical to more common three-contact stereo audio-only 3.5 mm TRS connector. DisplayPort
A 3.5 mm phone connector A 3.5 mm 4-conductor TRRS phone connector A 3.5 mm 5-conductor TRRRS phone connector. In the most common arrangement, consistent with the original intention of the design, the male plug is connected to a cable, and the female socket is mounted in a piece of equipment.
For similar reasons, "wye"-cables (or "Y-splitters") should not be used to combine two line out signals into a single line in. Each line output would be driving the other line output as well as the intended input, again resulting in a much heavier load than designed for. This will result in signal loss and possibly even damage.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
The magnetic immunity of star quad cable is a function of the accuracy of the star-quad geometry, the accuracy of the impedance balancing, and the common-mode rejection ratio of the balanced receiver. [2] Star-quad cable typically provides a 10 dB to 30 dB reduction [3] in magnetically-induced interference. [4] [5] [6]
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.