Search results
Results from the WOW.Com Content Network
In computer networking, the Point-to-Point Protocol over ATM (PPPoA) is a layer 2 data-link protocol typically used to connect domestic broadband modems to ISPs via phone lines. It is used mainly with DOCSIS and DSL carriers, by encapsulating PPP frames in ATM AAL5 .
PPPoE is used to connect a PC or a router to a modem via an Ethernet link and it can also be used in Internet access over DSL on a telephone line in the PPPoE over ATM (PPPoEoA) over ADSL protocol stack. PPPoE over ATM has the highest overhead of the popular DSL delivery methods, when compared with for example PPPoA (RFC 2364). [11] [12] [13] [14]
PPP, PPPoE and PPPoA are widely used in WAN lines. PPP is a layered protocol that has three components: [4] An encapsulation component that is used to transmit datagrams over the specified physical layer. A Link Control Protocol (LCP) to establish, configure, and test the link as well as negotiate settings, options and the use of features.
In the case of ATM or Frame Relay based access, individual subscribers are identified by Virtual Circuit IDs. Subscribers connected over Ethernet-based remote access devices are usually identified by VLAN IDs or MPLS tags. By acting as the network termination point, the BRAS is responsible for assigning network parameters such as IP addresses ...
While it has initially been used to manage only dial-up access, it is also used to manage broadband connections such as DSL, if Point-to-Point Protocol over Ethernet (PPPoE) or Point-to-Point Protocol over ATM (PPPoA) is used. The role of pppd is managing PPP session establishment and session termination.
One convenient means to provide a PPS signal to a computer system is to connect that signal to a modem-control pin on a serial-line interface to the computer. The Data Carrier Detect (DCD) pin is frequently used for this purpose. Typically, the time-code output of the time source is transmitted to the computer over the same serial line.
ATM point-to-point connections (virtual circuits), on the other hand, are bidirectional, allowing data to flow in both directions over the same path. [f] Both ATM and MPLS support tunneling of connections inside connections. MPLS uses label stacking to accomplish this while ATM uses virtual paths. MPLS can stack multiple labels to form tunnels ...
Multiprotocol Encapsulation over ATM is specified in RFC 2684. It defines two mechanisms for identifying the protocol carried in ATM Adaptation Layer 5 (AAL5) frames. It replaces RFC 1483, a standard data link access protocol supported by DSL modems .