Search results
Results from the WOW.Com Content Network
Saturated unit weight The unit weight of a soil when all void spaces of the soil are completely filled with water, with no air. The formula for saturated unit weight is: = (+) + where γ s is the saturated unit weight of the material; γ w is the unit weight of water; G s is the specific gravity of the solid; e is the void ratio [3] Submerged ...
K D = around 10 for artificial interlocking concrete blocks; S r = (ρ r / ρ w is the relative density of rock, i.e. (ρ r / ρ w - 1) = around 1.58 for granite in sea water; ρ r and ρ w are the densities of rock and (sea)water (-) θ is the angle of revetment with the horizontal
Water content or moisture content is the quantity of water contained in a material, such as soil (called soil moisture), rock, ceramics, crops, or wood. Water content is used in a wide range of scientific and technical areas, and is expressed as a ratio, which can range from 0 (completely dry) to the value of the materials' porosity at saturation.
Changes of pore water content due to drying or wetting processes cause significant volume changes of concrete in load-free specimens. They are called the shrinkage (typically causing strains between 0.0002 and 0.0005, and in low strength concretes even 0.0012) or swelling (< 0.00005 in normal concretes, < 0.00020 in high strength concretes).
Materials such as stones, sand and ceramics are considered 'dry' and have much lower equilibrium moisture content than organic material like wood and leather. [7] typically a fraction of a percent by weight when in equilibrium of air of Relative humidity 10% to 90%. This affects the rate that buildings need to dry out after construction ...
The ultimate strength of concrete is influenced by the water-cementitious ratio (w/cm), the design constituents, and the mixing, placement and curing methods employed.All things being equal, concrete with a lower water-cement (cementitious) ratio makes a stronger concrete than that with a higher ratio. [2]
γ′ is the effective unit weight when saturated or the total unit weight when not fully saturated. B is the width or the diameter of the foundation. φ′ is the effective internal angle of friction. K pγ is obtained graphically. Simplifications have been made to eliminate the need for K pγ. One such was done by Coduto, given below, and it ...
It is also known as the stiffness to weight ratio or specific stiffness. High specific modulus materials find wide application in aerospace applications where minimum structural weight is required. The dimensional analysis yields units of distance squared per time squared.