Search results
Results from the WOW.Com Content Network
The Proctor compaction test is a laboratory method of experimentally determining the optimal moisture content at which a given soil type will become most dense and achieve its maximum dry density. The test is named in honor of Ralph Roscoe Proctor [ de ] , who in 1933 showed that the dry density of a soil for a given compactive effort depends ...
Saturated unit weight The unit weight of a soil when all void spaces of the soil are completely filled with water, with no air. The formula for saturated unit weight is: = (+) + where γ s is the saturated unit weight of the material; γ w is the unit weight of water; G s is the specific gravity of the solid; e is the void ratio [3] Submerged ...
Water content or moisture content is the quantity of water contained in a material, such as soil (called soil moisture), rock, ceramics, crops, or wood. Water content is used in a wide range of scientific and technical areas, and is expressed as a ratio, which can range from 0 (completely dry) to the value of the materials' porosity at saturation.
The cement industry uses the LOI method by heating a cement sample to 900-1000 °C until the mass of the sample stabilizes. Once the mass stabilizes, the mass loss due to LOI is determined. This is usually done to assess the high water content in the cement or carbonation, as these factors diminish the quality of cement. [10]
Materials such as stones, sand and ceramics are considered 'dry' and have much lower equilibrium moisture content than organic material like wood and leather. [7] typically a fraction of a percent by weight when in equilibrium of air of Relative humidity 10% to 90%. This affects the rate that buildings need to dry out after construction ...
More water is therefore used than is chemically and physically necessary to react with cement. Water–cement ratios in the range of 0.40 to 0.60 are typically used. For higher-strength concrete, lower w/c ratios are necessary, along with a plasticizer to increase flowability.
The ultimate strength of concrete is influenced by the water-cementitious ratio (w/cm), the design constituents, and the mixing, placement and curing methods employed. All things being equal, concrete with a lower water-cement (cementitious) ratio makes a stronger concrete than that with a higher ratio. [2]
The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the ...