Ads
related to: usb rs232 driver for xp 5 8 gypsum board r value
Search results
Results from the WOW.Com Content Network
FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
The physical hardware communications link (physical layer) is not defined by SCPI. [5] While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer ...
The change prevents the chip from being recognised by drivers of any OS, effectively making them inoperable unless the product ID is changed back. [14] The behaviour was supported by a notice in the drivers' end user license agreement, which warned that use of the drivers with non-genuine FTDI products would "irretrievably damage" them. [14]
Adaptec also developed generic SCSI disk and CD-ROM drivers for DOS (ASPICD.SYS and ASPIDISK.SYS). [3]: 60–61 At least a couple of other programming interfaces for SCSI device drivers competed with ASPI in the early 1990s, including CAM (Common Access Method), developed by Apple; and Layered Device Driver Architecture, developed by Microsoft.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
This class can be used for industrial equipment such as CNC machinery to allow upgrading from older RS-232 serial controllers and robotics, since they can keep software compatibility. The device attaches to an RS-232 communications line and the operating system on the USB side makes the USB device appear as a traditional RS-232 port.
ARINC 429 is a data transfer standard for aircraft avionics. It uses a self-clocking, self-synchronizing data bus protocol (Tx and Rx are on separate ports). The physical connection wires are twisted pairs carrying balanced differential signaling.
Ads
related to: usb rs232 driver for xp 5 8 gypsum board r value