enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Air-blast injection - Wikipedia

    en.wikipedia.org/wiki/Air-blast_injection

    A separate cam on the camshaft (as seen in Fig. 5 and on the two-cylinder Johann-Weitzer-engine on the right) would activate the injection valve so the compressed air would then press the fuel into the combustion chamber. Before the injection valve opens, neither fuel nor compressed air can enter the combustion chamber. [16]

  3. Piping and instrumentation diagram - Wikipedia

    en.wikipedia.org/wiki/Piping_and_instrumentation...

    P&IDs are originally drawn up at the design stage from a combination of process flow sheet data, the mechanical process equipment design, and the instrumentation engineering design. During the design stage, the diagram also provides the basis for the development of system control schemes, allowing for further safety and operational ...

  4. Fuel injection - Wikipedia

    en.wikipedia.org/wiki/Fuel_injection

    Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.

  5. Anti-dribble valve - Wikipedia

    en.wikipedia.org/wiki/Anti-dribble_valve

    These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [i] held against a matching conical seat by a spring. As these valves must work at high pressure ...

  6. Two-stroke diesel engine - Wikipedia

    en.wikipedia.org/wiki/Two-stroke_diesel_engine

    The power stroke begins at TDC ([0°]; injection of fuel leads TDC by 4° [356°], such that injection of fuel will be completed by TDC or very shortly thereafter; [citation needed] the fuel ignites as fast as it is injected), after the power stroke the exhaust valves are opened, thereby greatly reducing combustion gas pressure and temperature ...

  7. Crankcase ventilation system - Wikipedia

    en.wikipedia.org/wiki/Crankcase_ventilation_system

    This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.

  8. Combustion chamber - Wikipedia

    en.wikipedia.org/wiki/Combustion_chamber

    Indirect injection, where the fuel is injected into a swirl chamber or pre-combustion chamber. The fuel ignites as it is injected into this chamber and the burning air/fuel mixture spreads into the main combustion chamber. Direct injection engines usually give better fuel economy but indirect injection engines can use a lower grade of fuel.

  9. Secondary air injection - Wikipedia

    en.wikipedia.org/wiki/Secondary_air_injection

    A sensitive reed valve assembly called the aspirator valve is placed in the air injection pumping, which draws its air directly from the clean side of the air filter. During engine idle, brief but periodic negative pressure pulses in the exhaust system draw air through the aspirator valve and into the exhaust stream at the catalytic converter.