Search results
Results from the WOW.Com Content Network
This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.
A separate cam on the camshaft (as seen in Fig. 5 and on the two-cylinder Johann-Weitzer-engine on the right) would activate the injection valve so the compressed air would then press the fuel into the combustion chamber. Before the injection valve opens, neither fuel nor compressed air can enter the combustion chamber. [16]
A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.
Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.
Common rail fuel system on a Volvo truck engine. In 1916 Vickers pioneered the use of mechanical common rail systems in G-class submarine engines. For every 90° of rotation, four plunger pumps allowed a constant injection pressure of 3,000 pounds per square inch (210 bar; 21 MPa), with fuel delivery to individual cylinders being shut off by valves in the injector lines. [1]
In a blast furnace, fuel , ores, and flux are continuously supplied through the top of the furnace, while a hot blast of air (sometimes with oxygen enrichment) is blown into the lower section of the furnace through a series of pipes called tuyeres, so that the chemical reactions take place throughout the furnace as the material falls downward.
FBC smoke tube boiler. Fluidized bed combustion (FBC) is a combustion technology used to burn solid fuels.. In its most basic form, fuel particles are suspended in a hot, bubbling fluidity bed of ash and other particulate materials (sand, limestone etc.) through which jets of air are blown to provide the oxygen required for combustion or gasification.
These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [i] held against a matching conical seat by a spring. As these valves must work at high pressure ...