Search results
Results from the WOW.Com Content Network
Levels of evapotranspiration in a given area are primarily controlled by three factors: [10] Firstly, the amount of water present. Secondly, the amount of energy present in the air and soil (e.g. heat, measured by the global surface temperature ); and thirdly the ability of the atmosphere to take up water ( humidity ).
Two major factors influence the rate of water flow from the soil to the roots: the hydraulic conductivity of the soil and the magnitude of the pressure gradient through the soil. Both of these factors influence the rate of bulk flow of water moving from the roots to the stomatal pores in the leaves via the xylem. [7]
Monthly estimated potential evapotranspiration and measured pan evaporation for two locations in Hawaii, Hilo and Pahala. Potential evapotranspiration is usually measured indirectly, from other climatic factors, but also depends on the surface type, such as free water (for lakes and oceans), the soil type for bare soil, and also the density and diversity of vegetation.
The Penman-Monteith equation approximates net evapotranspiration (ET) from meteorological data as a replacement for direct measurement of evapotranspiration. The equation is widely used, and was derived by the United Nations Food and Agriculture Organization for modeling reference evapotranspiration ET 0 .
When water evaporates, it takes up energy from its surroundings and cools the environment. When it condenses, it releases energy and warms the environment. These heat exchanges influence the climate system. The evaporative phase of the cycle purifies water because it causes salts and other solids picked up during the cycle to be left behind.
Factors like full sunshine in forested areas and deserts can affect the transfer of moisture in the air. Increased amounts of evaporation or transpiration will cause a reduction in atmospheric pressure as clouds form, which will subsequently cause moist air to be drawn to regions where evapotranspiration is at its highest.
It is a steel container 1.83 m (6 ft) on a side and 0.61 m (2 ft) deep, sunk into the ground with an above-ground rim of 7.6–10 centimetres (3.0–3.9 in) and is painted black internally. Its evaporation rate is lower than the Class A pan and conversion factors must be used. [8]
The movement of heat embodied in water vapour as it leaves vegetation is not well understood given the complexity of the dynamics. [11] While the movement of water into the atmosphere through evapotranspiration and consequent cooling is broadly accepted, the movement of water further into the atmosphere is more contentious. [12]