Search results
Results from the WOW.Com Content Network
"Normal" ion generators (that produce negative ions) produce them via a voltage usually around 10,000 volts. To increase the amount of ions produced the amperage is increased, not the voltage. If you increase the voltage beyond say 14,000 volts then you start to produce too much ozone and not enough ions instead.
It consists of a TP4056 charger/controller (Photo 2) connected to a 3.7v/3Ah Lithium Ion battery to supply a low battery level indicator, and a load (three white leds and two fans) through a MT3608 Step Up to raise voltage from 3.7v to 9v.
Feb 7, 2015. #2. Well, since you are never supposed to discharge a lead acid battery below about 11.0V, that circuit, even if it worked is pretty useless. A fully-charged lead-acid chemistry battery, 12h or so after it comes off the charger is 13.2V to 12.7V. One that is totally discharged is 11.5 to 11.0V.
And the extra electron from the 5 electron atom in the N-type is gone, so now that atom is a positive ion. So the time it takes to make the transfer is unimportant. It is the transfer itself, not how fast it is done that determines the ion count and thereby the barrier voltage.
May 5, 2010. #6. ozone, (O3) is a very unstable molecule. the most relaxed state that oxygen atoms can be in is in the configuration, O2. So ozone won't be around long anyways. if you are really adamant about it though, the only other way is to use the negative ion generator in a non-oxygen atmosphere, such as helium, or argon. however, If you ...
I have 60 free lithium ion batteries. They all test, 3.8v, 3.9v, 4.0v, 4.1v. I ordered 2 chargers that will charge 1 battery each. I ordered another charger that will charge 2 batteries at a time. Digital read out that shows the original battery voltage, it also shows voltage as battery...
Hi, I'm wondering if is ok to use a DC/DC Boost Step-up regulator (like **broken link removed**, LTC3862-2 or LTC3873-5) as charger for a lithium ion battery pack (42V 2A charging specs). I want to build a simple charger with those specifications : input DC source (input 18-24V/4A)...
If your input voltage is the same as your output, the base resistor is 10 times the resistance of the collector resistor. For your 555 circuit, try a 10K on the base and a 1K on the collector. A 2n3904 or 2n2222 should work fine as will almost any small NPN transistor you might have around. I tried a 200 ohm pullup resistor, but my finger could ...
Lithium Ion batteries also cause a pretty big problem if shorted. They can ignite and explode quite vividly. There are vids on the web. I know someone who had a Lead Acid car battery blow up right under their chin just about. Very luckily there was no injury. Battery case pieces all over the back yard though.
Mar 29, 2008. #2. I fail to see how the circuit will work for several reasons. 1. Q1 and Q2 are PNP transistors and the collectors are tied to the + 9V. supply. This is the wrong polarity for PNP transistors. Perhaps the schematic is wrong and the emitters should be connected to the +9V. 2.