Search results
Results from the WOW.Com Content Network
As the address pushed to the stack is that of the aborted instruction rather than the contents of the program counter, executing an RTI (ReTurn from Interrupt) following an ABORT interrupt will cause the processor to return to the aborted instruction, rather than the next instruction, as would be the case with the other interrupts.
Signal handlers can instead put the signal into a queue and immediately return. The main thread will then continue "uninterrupted" until signals are taken from the queue, such as in an event loop. "Uninterrupted" here means that operations that block may return prematurely and must be resumed, as mentioned above.
Common exceptions include an invalid argument (e.g. value is outside of the domain of a function), [5] an unavailable resource (like a missing file, [6] a network drive error, [7] or out-of-memory errors [8]), or that the routine has detected a normal condition that requires special handling, e.g., attention, end of file. [9]
In the C Standard Library, signal processing defines how a program handles various signals while it executes. A signal can report some exceptional behavior within the program (such as division by zero), or a signal can report some asynchronous event outside the program (such as someone striking an interactive attention key on a keyboard).
While performing this translation of technical errors into meaningful user messages, specific errors are often grouped into more generic errors, and this process can lead to user messages becoming so useless that the user doesn't know what went wrong or how to fix it.
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
Hardware interrupts may be mapped to any of the vectors by way of a programmable interrupt controller. On the 80286 and later, the size and locations of the IVT can be changed in the same way as it is done with the IDT (Interrupt descriptor table) in protected mode (i.e., via the LIDT (Load Interrupt Descriptor Table Register) instruction ...
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card , key presses, or mouse movements.