enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Steam accumulator - Wikipedia

   en.wikipedia.org/wiki/Steam_accumulator

   A steam accumulator is an insulated steel pressure tank containing hot water and steam under pressure. It is a type of energy storage device. It can be used to smooth out peaks and troughs in demand for steam. Steam accumulators may take on a significance for energy storage in solar thermal energy projects. An example is the PS10 solar power ...

3. Pressure tank - Wikipedia

   en.wikipedia.org/wiki/Pressure_tank

   The diaphragm or bladder may itself exert a pressure on the water, but it is usually small and will be neglected in the following discussion. Case 1 is an empty tank at the charging pressure P c (gauge). The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V. Referring ...

4. Thermal energy storage - Wikipedia

   en.wikipedia.org/wiki/Thermal_energy_storage

   A steam accumulator consists of an insulated steel pressure tank containing hot water and steam under pressure. As a heat storage device, it is used to mediate heat production by a variable or steady source from a variable demand for heat. Steam accumulators may take on a significance for energy storage in solar thermal energy projects.

5. Hydraulic accumulator - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_accumulator

   As the volume of the compressed gas changes, the pressure of the gas (and the pressure on the fluid) changes inversely. For low pressure water system use the water usually fills a rubber bladder within the tank (pictured), preventing contact with the tank which would otherwise need to be corrosion resistant.

6. Layered charge storage - Wikipedia

   en.wikipedia.org/wiki/Layered_charge_storage

   Layered or stratified charge storage is hot water storage tank, typically for solar thermal energy. The warmest storage layer is the top storage cylinder and below this there are colder storage layers through natural layering. The water is fed into different storage levels, depending on the available feed temperature and current temperature ...

7. Maximum allowable operating pressure - Wikipedia

   en.wikipedia.org/wiki/Maximum_allowable...

   Maximum Allowable Operating Pressure (MAOP) is a pressure limit set, usually by a government body, which applies to compressed gas pressure vessels, pipelines, and storage tanks. For pipelines, this value is derived from Barlow's Formula , which takes into account wall thickness, diameter, allowable stress (which is a function of the material ...

8. Compressed-air energy storage - Wikipedia

   en.wikipedia.org/wiki/Compressed-air_energy_storage

   Environmental impact assessments, land use approvals, and safety standards for high-pressure storage systems can delay or increase costs for CAES projects. For example, projects sited near urban areas often face additional scrutiny due to concerns about noise pollution, air quality, and potential risks associated with high-pressure air storage.

9. Storage water heater - Wikipedia

   en.wikipedia.org/wiki/Storage_water_heater

   Solar heat is clean and renewable. This is the most modern system. Increasingly, solar powered water heaters are being used. Their solar thermal collectors are installed outside dwellings, typically on the roof or walls or nearby, and the potable hot water storage tank is typically a pre-existing or new conventional water heater, or a water heater specifically designed for solar thermal.