enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oil pump (internal combustion engine) - Wikipedia

   en.wikipedia.org/wiki/Oil_pump_(internal...

   The oil pump forces the motor oil through the passages in the engine to properly distribute oil to different engine components. In a common oiling system, oil is drawn out of the oil sump (oil pan, in US English) through a wire mesh strainer that removes some of the larger pieces of debris from the oil.

3. Compression release - Wikipedia

   en.wikipedia.org/wiki/Compression_release

   Once the engine spins to starting speed, centrifugal force causes the lever to move out of the way, and the exhaust valve is allowed to seat fully. [4] Older compression release systems used a small bump on the cam that would bump the valve very slightly at low speeds. Once the engine gained speed, the pressure would push the exhaust valve ...

4. Diaphragm pump - Wikipedia

   en.wikipedia.org/wiki/Diaphragm_pump

   A diaphragm pump (also known as a Membrane pump) is a positive displacement pump that uses a combination of the reciprocating action of a rubber, thermoplastic or teflon diaphragm and suitable valves on either side of the diaphragm (check valve, butterfly valves, flap valves, or any other form of shut-off valves) to pump a fluid.

5. Pneumatic valve springs - Wikipedia

   en.wikipedia.org/wiki/Pneumatic_valve_springs

   Pneumatic valve springs are also found in several Moto GP motorcycle engines, debuting in 2002 with the Aprilia RS Cube. In 2005, Team Roberts was the first to use pneumatic valves full-time in their uncompetitive KTM powered bike. Today, almost all of the MotoGP teams use pneumatic valve technology on their bikes, including Yamaha, Suzuki and ...

6. Hydrolock - Wikipedia

   en.wikipedia.org/wiki/Hydrolock

   In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.

7. Blowoff valve - Wikipedia

   en.wikipedia.org/wiki/Blowoff_valve

   A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.

8. Compression release engine brake - Wikipedia

   en.wikipedia.org/wiki/Compression_release_engine...

   The typical compression brake consists of a hydraulic system using engine oil which transfers the motion of the fuel injector rocker arm to the engine's exhaust valve(s). When activated, the exhaust valve opens very briefly near the engine's top dead center , and releases the compressed air in the cylinder so that the air compression energy is ...

9. Hydraulic tappet - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_tappet

   Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a valve shuts the oil inlet. Oil is ...