enow.com Web Search

  1. Ad

    related to: high low converter for amp controller manual instructions download

Search results

  1. Results from the WOW.Com Content Network
  2. Level shifter - Wikipedia

    en.wikipedia.org/wiki/Level_shifter

    74LVC1T45, 1-bit bidirectional with direction control, dual-supply of 1.65V-5.5V translated to 1.65V-5.5V, available only in SMD packages. 2-bit 74LVC2T45 and 8-bit 74LVC8T245 exist too. 4504B , 6-bit unidirectional, dual-supply of 5V TTL or 5V-18V CMOS translated to 5V-18V CMOS, available in DIP or SMD packages.

  3. Cypress PSoC - Wikipedia

    en.wikipedia.org/wiki/Cypress_PSoC

    There are two types of analog blocks. The continuous time (CT) blocks are composed of an op-amp circuit and designated as ACBxx where xx is 00–03. The other type is the switch cap (SC) blocks, which allow complex analog signal flows and are designated by ASCxy where x is the row and y is the column of the analog block.

  4. Buck converter - Wikipedia

    en.wikipedia.org/wiki/Buck_converter

    Because the low-side V GS is the gate driver supply voltage, this results in very similar V GS values for high-side and low-side MOSFETs. A complete design for a buck converter includes a tradeoff analysis of the various power losses. Designers balance these losses according to the expected uses of the finished design.

  5. Charge amplifier - Wikipedia

    en.wikipedia.org/wiki/Charge_amplifier

    Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A parasitic effect of common coaxial sensor ...

  6. H-bridge - Wikipedia

    en.wikipedia.org/wiki/H-bridge

    Most DC-to-AC converters (power inverters), most AC/AC converters, the DC-to-DC push–pull converter, isolated DC-to-DC converter [2] most motor controllers, and many other kinds of power electronics use H bridges. In particular, a bipolar stepper motor is almost always driven by a motor controller containing two H bridges.

  7. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  8. Chopper (electronics) - Wikipedia

    en.wikipedia.org/wiki/Chopper_(electronics)

    Essentially, a chopper is an electronic switch that is used to interrupt one signal under the control of another. In power electronics applications, since the switching element is either fully on or fully off, its losses are low and the circuit can provide high efficiency. However, the current supplied to the load is discontinuous and may ...

  9. Single-ended primary-inductor converter - Wikipedia

    en.wikipedia.org/wiki/Single-ended_primary...

    The single-ended primary-inductor converter (SEPIC) is a type of DC/DC converter that allows the electrical potential at its output to be greater than, less than, or equal to that at its input. The output of the SEPIC is controlled by the duty cycle of the electronic switch (S1).

  1. Ad

    related to: high low converter for amp controller manual instructions download