Search results
Results from the WOW.Com Content Network
Port mirroring on a Cisco Systems switch is generally referred to as Switched Port Analyzer (SPAN) or Remote Switched Port Analyzer (RSPAN). Other vendors have different names for it, such as Roving Analysis Port (RAP) on 3Com switches. Network engineers or administrators use port mirroring to analyze and debug data or diagnose errors on a ...
A switch virtual interface (SVI) represents a logical layer-3 interface on a switch. VLANs divide broadcast domains in a LAN environment. Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing.
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
Cisco's IOS software maintains one IDB for each hardware interface in a particular Cisco switch or router and one IDB for each subinterface. The number of IDBs present in a system varies with the Cisco hardware platform type. Physical and logical interfaces on the switch will be referenced with either expanded or abbreviated port description names.
Through port mirroring, a switch can create a mirror image of data that can go to an external device, such as intrusion detection systems and packet sniffers. A modern switch may implement power over Ethernet (PoE), which avoids the need for attached devices, such as a VoIP phone or wireless access point, to have a separate power supply.
The port will not send out DTP frames or be affected by any incoming DTP frames. If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode.
An ICD is the umbrella document over the system interfaces; examples of what these interface specifications should describe include: The inputs and outputs of a single system, documented in individual SIRS (Software Interface Requirements Specifications) and HIRS (Hardware Interface Requirements Specifications) documents, would fall under "The Wikipedia Interface Control Document".
Intermediate drivers sit in-between the MAC and IP layers and can control all traffic being accepted by the NIC. In practice, intermediate drivers implement both miniport and protocol interfaces. The miniport driver and protocol driver actually communicate with the corresponding miniport and protocol interfaces that reside in the intermediate ...