Search results
Results from the WOW.Com Content Network
Gusset plates are usually square or rectangular, but can be triangular or made into a customized shape to fit the joint. The shape of each plate is designed so that welding or bolts can be applied to different edges of the plate. [2] A gusset plate can form the entire connection or it can be used in conjunction with bolts or welds. [2]
The stiffeners are usually considered pinned end. Power plant ductwork can be 5/16" thick duct plate, with "fixed end" W stiffeners at roughly 2'-5" spacing. Because rectangular duct plate bends, stiffeners are required at reasonably close spacing. Duct plate 3/16", or thinner, may dishpan, or make noise, and should be avoided.
Finally, the stiffeners increase the resistance of the plate to buckling. The same structural effects are also true of the concrete slab in a composite girder bridge, but the steel orthotropic deck is considerably lighter, and therefore allows longer span bridges to be more efficiently designed.
An SPW frame can be idealized as a vertical cantilever plate girder, in which the steel plates act as the web, the columns act as the flanges and the cross beams represent the transverse stiffeners. The theory that governs plate design should not be used in the design of SPW structures since the relatively high bending strength and stiffness of ...
[citation needed] The term isogrid is used because the structure acts like an isotropic material, with equal properties measured in any direction, and grid, referring to the sheet and stiffeners structure. [citation needed] A similar variant is the orthogrid (sometimes called a waffle grid), which uses rectangular rather than triangular openings.
Tertiary strength and loads are the forces, strength, and bending response of individual sections of hull plate between stiffeners, and the behaviour of individual stiffener sections. Usually the tertiary loading is simpler to calculate: for most sections, there is a simple, maximum hydrostatic load or hydrostatic plus slamming load to calculate.
In a plate girder bridge, the plate girders are typically I-beams made up from separate structural steel plates (rather than rolled as a single cross-section), which are welded or, in older bridges, bolted or riveted together to form the vertical web and horizontal flanges of the beam. In some cases, the plate girders may be formed in a Z-shape ...
In bookbinding, stiffening is a process whereby paperback books are reinforced for use in libraries, without change to their fundamental binding structure. It is in use at several academic libraries in the United States, including those at Cornell University and Johns Hopkins University.