Search results
Results from the WOW.Com Content Network
This article presents a list of commands used by MS-DOS compatible operating systems, especially as used on IBM PC compatibles. Many unrelated disk operating systems use the DOS acronym and are not part of the scope of this list. In MS-DOS, many standard system commands are provided for common tasks such as listing files on a disk or moving ...
HDAT2 a free software program for MS-DOS. It can be used to create/remove Host Protected Area (HPA) (using command SET MAX) and create/remove DCO hidden area (using command DCO MODIFY). It also can do other functions on the DCO. Data Synergy's freeware ATATool utility can be used to detect a DCO from a Windows environment. Recent versions allow ...
MS-DOS / PC DOS and some related disk operating systems use the files mentioned here. System Files: [1] IO.SYS (or IBMBIO.COM): This contains the system initialization code and builtin device drivers; MSDOS.SYS (or IBMDOS.COM): This contains the DOS kernel. Command-line interpreter (Shell): COMMAND.COM: This is the command interpreter.
In Excel and Word 95 and prior editions a weak protection algorithm is used that converts a password to a 16-bit verifier and a 16-byte XOR obfuscation array [1] key. [4] Hacking software is now readily available to find a 16-byte key and decrypt the password-protected document. [5] Office 97, 2000, XP and 2003 use RC4 with 40 bits. [4]
The partition type (or partition ID) in a partition's entry in the partition table inside a master boot record (MBR) is a byte value intended to specify the file system the partition contains or to flag special access methods used to access these partitions (e.g. special CHS mappings, LBA access, logical mapped geometries, special driver access, hidden partitions, secured or encrypted file ...
For example, if the second or third hard disk is of SCSI type and, on DOS, requires drivers loaded through the CONFIG.SYS file (e.g. the controller card does not offer on-board BIOS or using this BIOS is not practical), then the first SCSI primary partition will appear after all the IDE partitions on DOS. Therefore, DOS and for example OS/2 ...
(For articles about commands not built into the command processor see category External DOS commands.) Pages in category "Internal DOS commands" The following 32 pages are in this category, out of 32 total.
Specifically, the above will create a 2 GB logical partition, provided that adequate space is available, and assign it the drive letter 'F:'. [5] The installed disks and their associated volumes and/or partitions can be viewed using these commands: list disk list volume list partition The sel command will select them.