Search results
Results from the WOW.Com Content Network
In these types of pumps the volute casing is split axially and the split line at which the pump casing separates is at the shaft's centerline. They are typically mounted horizontally due to ease in installation and maintenance. Radial split: The pump case is split radially, the volute casing split is perpendicular to shaft centre line.
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.
Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...
The flow rate is an important parameter for a pump. The flow rate in a peristaltic pump is determined by many factors, such as: Tube inner diameter – higher flow rate with larger inner diameter. Pump-head outer diameter – higher flow rate with larger outer diameter. Pump-head rotational speed – higher flow rate with higher speed.
These kinds of piston pumps are characterized by the following advantages: high efficiency; high pressure (up to 1,000 bar or 14000psi) low flow and pressure ripple (due to the small dead volume in the workspace of the pumping piston) low noise level; very high load at lowest speed due to the hydrostatically balanced parts possible
If the pump flow is higher than design the velocity will increase across the volute and the pressure will decrease according to the first law of thermodynamics. This will cause a side thrust in the opposite direction to that caused by low flow but the result is the same – vibration with resultant short bearing and seal life.