Search results
Results from the WOW.Com Content Network
The first-generation iPad Pro (12.9-inch models only), and the second-generation iPad Pro, are the only devices in which the Lightning connector supports USB 3.0 host. [9] The only accessory released with USB 3.0 support is the Lightning to USB 3 Camera Adapter.
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
USB bridge cables, or data transfer cables can be found within the market, offering direct PC to PC connections. A bridge cable is a special cable with a chip and active electronics in the middle of the cable. The chip in the middle of the cable acts as a peripheral to both computers and allows for peer-to-peer communication between the computers.
Charging docks supply power and do not include a host device or data pins, allowing any capable USB device to charge or operate from a standard USB cable. Charging cables provide power connections, but not data. In a charge-only cable, the data wires are shorted at the device end, otherwise, the device may reject the charger as unsuitable.
Verified for iOS 9.3 and later. 1. Double press the Home button or swipe up and hold. 2. Swipe up on the image of the app. 3. Re-launch the app and attempt to reproduce the issue.
The tenth-generation iPad uses an A14 Bionic processor, previously seen in the fourth-generation iPad Air and the iPhone 12 in 2020. The chip has a 6-core CPU, a 4-core GPU, and a 16-core Neural Engine. [7] The tenth-generation iPad has Bluetooth 5.2 and Wi-Fi 6 (802.11ax) wireless capabilities, as well as sub-6 GHz 5G on cellular models
Quick Charge is a proprietary technology that can charge battery-powered devices, primarily mobile phones, at power levels exceeding the 7.5 watts (5 volts at 1.5 amps) supported by the USB BC 1.2 standard, using existing USB cables. The higher voltage available allows more power (watts) to be supplied through wires without excessive heating.
On 25 July 2017, a press release from the USB 3.0 Promoter Group detailed a pending update to the USB Type-C specification, defining the doubling of bandwidth for existing USB-C cables. Under the USB 3.2 specification, released 22 September 2017, [11] existing SuperSpeed certified USB-C 3.1 Gen 1 cables will be able to operate at 10 Gbit/s (up ...