Ad
related to: sterling 10.5 axle locker
Search results
Results from the WOW.Com Content Network
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Saginaw 9.5-inch axle; Sterling 10.5 axle This page was ...
The F-250 and F-350 single-rear-wheel versions were fitted with a 10.5-inch (270 mm) Sterling 10.5 35-spline axle with choices of conventional or limited-slip differentials; initially developed for previous-generation Ford trucks, it was strengthened for use in the Super Duty. In dual-rear-wheel F-350s, the rear axle was a Dana 80.
The four-wheel-drive models had an NV273 transfer case and Dana 50 front axle. Rear axle ratios of 3.73:1 and 4.30:1 were offered. Rear axle ratios of 3.73:1 and 4.30:1 were offered. During the development of the chassis, Ford learned that its initial design caused smaller vehicles (such as a Ford Taurus ) to become severely overridden in a ...
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
Ad
related to: sterling 10.5 axle locker