Search results
Results from the WOW.Com Content Network
In a horizontal or vertical cable rail, the cables, once tensioned must be rigid enough to prevent a 4-inch sphere passing through it. Factors influencing this rigidity are: the tension of the cable, intermediate posts (or cable spacers) spacing, the diameter of the cable, top rail cap material and the cable to cable spacing. [7]
Measurement of track spacing from the rail head to rail head. By definition, the track spacing is given from centre to centre of a rail track. For an actual construction the distance is measured from the inside of a rail head to the matching one of the other track. As far as both tracks have the same gauge this is the same distance.
For example, North America uses the reference rail as the line rail which is the east rail of tangent track running north and south, the north rail of tangent track running east and west, the outer rail (the rail that is further away from the center) on curves, or the outside rails in multiple track territory. [6]
The term derives from the "gauge", a metal bar with a precisely positioned lug at each end that track crews use to ensure the actual distance between the rails lies within tolerances of a prescribed standard: on curves, for example, the spacing is wider than normal. [2]
These include simple rail adhesion, rack railways and cable inclines (including rail mounted water tanks to carry barges). To help with braking on the descent, a non-load-bearing "brake rail" located between the running rails can be used, similar to the rail used in the Fell system, e.g. by the Snaefell Mountain Railway on the Isle of Man.
Notwithstanding these formulas it is widely known that reducing headway increases risk of collision in standard private automobile settings and is often referred to as tailgating. 2) metro system, per line: 40 km/h (~11 m/s) speeds, 1000 passengers, 100 meter vehicle length, 0.5 m/s^2 braking, 2 second reaction time, brick-wall stop, k ...
90-foot (27.43 m) radii on the elevated 4 ft 8 + 1 ⁄ 2 in (1,435 mm) standard gauge Chicago 'L'. There is no room for longer radii at this cross junction in the northwest corner of the Loop . The minimum railway curve radius is the shortest allowable design radius for the centerline of railway tracks under a particular set of conditions.
The typical deck railing is generally built from pressure treated lumber. [14] Posts on a deck are also typically pressure treated wood and standard sizes are 4x4, 6x6, and 8x8. These posts give structural support to the railing assembly and are the most critical part for the safety of the guard rail assembly. [15]