Search results
Results from the WOW.Com Content Network
A Glock switch functions by applying force to a semi-automatic pistol's trigger bar to prevent it from limiting fire to one round of ammunition per trigger pull. [5] [6] Normally, in a semiautomatic pistol, after firing, the trigger bar catches the firing pin until the trigger is released, but when depressed by the switch it does not catch.
Examples of the variety of typical semi-auto mechanisms are a stiff double-action trigger pull with the safety off (Beretta 92F/FS), a double-action with no external safety (SIG Sauer P-series, or Kel-Tec P-32), or a crisp single-action trigger pull with a manual safety engaged (M1911, FN Five-seven and certain configurations of the HK USP).
A forced reset trigger (or "hard reset" trigger) is a device that allows a person to fire a semi-automatic firearm at an increased rate. The forced reset trigger works by mechanically resetting the trigger's position after a shot is fired. This allows for an increased rate of fire.
A Glock switch, a tiny device that can turn a handgun into a machine gun, continue to show up in Columbus. Glock switches: How use of small device that makes guns automatic exploded in Columbus ...
Pre-set triggers offer a balance of pull weight, trigger travel, safety, and consistency. Glock popularized this trigger in modern pistols [citation needed] and many other manufacturers have released pre-set striker products of their own. The primary disadvantage is that pulling the trigger a second time after a failure to fire will not re ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
The slide, barrel, and magazine were steel. The standard magazine held 10 rounds. At 17.1 oz (480 g) unloaded, the handgun itself was comparatively light. The P-11 lacked an external manual safety, relying instead on a long and heavy double action only trigger pull, which requires 9 pounds of pressure, to prevent accidental discharge. A firing ...