Ads
related to: pic development board with rs-232 cable and usb
Search results
Results from the WOW.Com Content Network
This is a 2003 era programmer for the Microchip "PIC" family of microcontrollers. It connects by RS 232 cable to a PC compatible running development software. In 2003 this unit cost $300 Canadian (about $200 US at the time). Devices called "programmers" are traditionally used to get program code into the target PIC.
This also allows downloads to be made with a simple serial connection which eliminates the need for a PIC programmer. [3] PICAXE is programmed using an RS-232 serial cable [4] or a USB cable [5] which connects a computer to the download circuit, which normally uses a 3.5 mm jack and two resistors. [6]
Arduino USB v2.0 Changed: USB replaces RS-232 interface, Improved: Arduino can be powered from host Arduino Extreme [1] ATmega8 [52] 16 MHz Arduino 81.3 mm × 53.3 mm [ 3.2 in × 2.1 in ] USB The Arduino Extreme uses many more surface mount components than previous USB Arduino boards and comes with female pin headers. [1]
The ELM327 abstracts the low-level protocol and presents a simple interface that can be called via a UART, typically by a hand-held diagnostic tool or a computer program connected by USB, RS-232, Bluetooth or Wi-Fi. [2] New applications include smartphones. [3] There are a large number of programs available that connect to the ELM327. [4] [5]
Arduino USB v2.0 Changed: USB replaces RS-232 interface, Improved: Arduino can be powered from host Arduino Extreme [45] Arduino Yes ATmega8 [44] 16 MHz Arduino 3.2 in × 2.1 in [ 81.3 mm × 53.3 mm ] USB The Arduino Extreme uses many more surface mount components than previous USB Arduino boards and comes with female pin headers. [45]
Easy boards Full-featured development boards with onboard programmers. Users can plug different microcontrollers via DIP sockets or specialized PCB cards. EasyPIC v7 (for 8-bit PIC microcontrollers) click boards 1600+ add-on boards with a standardized connector and form factor. Each board carries a single sensor or transceiver from numerous ...
It is also possible to connect to USB via RS-232 to USB converter, and even if the original standard for RS-232 was basically a point-to-point system for the serial port on PCs, it is still possible to use RS-232 in small local area network using micro-controller and source code to control the signals and data transmission.
A free IDE is available that supports the USB-connected ToolStick line of modular prototyping boards. These microcontrollers were originally developed by Cygnal. In 2012, the company introduced ARM-based mixed-signal MCUs with very low power and USB options, supported by free Eclipse-based tools.
Ads
related to: pic development board with rs-232 cable and usb