Search results
Results from the WOW.Com Content Network
The stated distance is 360 km (220 mi); the comma is the decimal separator in Germany. 10,000 meters; About 6.2 miles; 1 mil (the Scandinavian mile), now standardized as 10 km: 1 mil, the unit of measure commonly used in Norway and Sweden [152] used to be 11,295 m in Norway and 10,688 m in Sweden.
The CBR test is a penetration test in which a standard piston, with a diameter of 50 mm (1.969 in), is used to penetrate the soil at a standard rate of 1.25 mm/minute. Although the force increases with the depth of penetration, in most cases, it does not increase as quickly as it does for the standard crushed rock, so the ratio decreases.
The Rheinmetall Bordkanone 5, or BK-5, was a WWII-era German 50 mm autocannon primarily intended for use against Allied heavy bombers, such as the United States Army Air Forces's (USAAF) Boeing B-17 Flying Fortress.
[20] [21] [22] The decimal prefix for ten thousand, myria-(sometimes spelt myrio-), and the early binary prefixes double-(2×) and demi-( 1 / 2 ×) were parts of the original metric system adopted by France in 1795, [23] [d] but were not retained when the SI prefixes were internationally adopted by the 11th CGPM conference in 1960.
degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a minute. Therefore, to convert from a degrees minutes seconds format to a decimal degrees format, one may use the formula
Engineering notation or engineering form (also technical notation) is a version of scientific notation in which the exponent of ten is always selected to be divisible by three to match the common metric prefixes, i.e. scientific notation that aligns with powers of a thousand, for example, 531×10 3 instead of 5.31×10 5 (but on calculator displays written without the ×10 to save space).
Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think about them ["two-fifty", "five hundred", "seven-fifty"]. Machinists generally ...
The 50 mm continued to be popular for the remainder of the war, simply because it was easily transported by two men, and provided infantry with hitting power and a range capability greater than any other weapon readily available at the squad or section level. A total of 22,112,000 rounds of ammunition were produced for the weapon from 1939 to 1943.