enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Structural pipe fitting - Wikipedia

   en.wikipedia.org/wiki/Structural_pipe_fitting

   A structural pipe fitting, also known as a slip on pipe fitting, clamp or pipe clamp is used to build structures such as handrails, guardrails, and other types of pipe or tubular structure. They can also be used to build furniture and theatrical riggings. The fittings slip on the pipe and are usually locked down with a set screw.

3. Hold down (structural engineering) - Wikipedia

   en.wikipedia.org/wiki/Hold_down_(structural...

   The hold downs provide uplift resistance against the overturning moment imposed on the wall due to "in-plane" lateral load applied at the top of the wall. A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1]

4. Pipe clamp - Wikipedia

   en.wikipedia.org/wiki/Pipe_clamp

   A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

7. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...