Search results
Results from the WOW.Com Content Network
Blade pitch is measured relative to the aircraft body. It is usually described as "fine" or "low" for a more vertical blade angle, and "coarse" or "high" for a more horizontal blade angle. Blade pitch is normally described as a ratio of forward distance per rotation assuming no slip. Blade pitch acts much like the gearing of the final drive of ...
The efficiency of the propeller is influenced by the angle of attack (α). This is defined as α = Φ - θ, [28] where θ is the helix angle (the angle between the resultant relative velocity and the blade rotation direction) and Φ is the blade pitch angle. Very small pitch and helix angles give a good performance against resistance but ...
A constant-speed propeller is a variable-pitch propeller that automatically changes its blade pitch in order to maintain a chosen rotational speed, regardless of the operational conditions of the aircraft. This is achieved by use of a constant-speed unit (CSU) or propeller governor, which automatically changes the propeller's blade pitch.
An alternative design is the controllable-pitch propeller (CPP, or CRP for controllable-reversible pitch), where the blades are rotated normally to the drive shaft by additional machinery – usually hydraulics – at the hub and control linkages running down the shaft. This allows the drive machinery to operate at a constant speed while the ...
Collective angle of attack for the rotor main blades via the swashplate: Increase/decrease pitch angle of all main rotor blades equally, causing the aircraft to ascend/descend Increase/decrease torque. In some helicopters the throttle control(s) is a part of the collective stick. Rotor speed is kept basically constant throughout the flight.
The three critical flight dynamics parameters are the angles of rotation in three dimensions about the vehicle's center of gravity (cg), known as pitch, roll and yaw. These are collectively known as aircraft attitude , often principally relative to the atmospheric frame in normal flight, but also relative to terrain during takeoff or landing ...
The sizes of these regions vary with the blade pitch, rate of descent, and rotor rotational speed. When changing autorotative rotational speed, blade pitch, or rate of descent, the sizes of the regions change in relation to each other. The driven region, also called the propeller region, is the region at the end of the blades.
In adjustable-pitch propeller control system, the pilot has to adjust the propeller pitch angle and thus angle of attack of the propeller blades (typically with a lever) to achieve the desired propeller rotational speed. The increased pitch (blade angle of attack) increases the load on the engine and therefore slows it down, and vice versa.