enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...

3. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   Indexable bits with the same purpose, to be held either in indexable handles or in power tool chucks, are called nutsetters. A spinner handle is a shaft and handle with a drive fitting—most commonly 1 ⁄ 4 in (6.35 mm) square axle at the end for attaching interchangeable sockets. This allows one to use a single handle with a number of sizes ...

4. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Standards organizations define sets of sizes that are conventionally manufactured and stocked. For example, British Standard BS 328 defines 230 sizes from 0.2 mm to 25.0 mm. From 0.2 through 0.98 mm, sizes are defined as follows, where N is an integer from 2 through 9: N · 0.1 mm; N · 0.1 + 0.02 mm; N · 0.1 + 0.05 mm; N · 0.1 + 0.08 mm

5. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Bits also differ by the diameter of their shank, with 1 ⁄ 2-inch, 12 mm, 10 mm, 3 ⁄ 8-inch, 8 mm and 1 ⁄ 4-inch and 6 mm shanks (ordered from thickest to thinnest) being the most common. Half-inch bits cost more but, being stiffer, are less prone to vibration (giving smoother cuts) and are less likely to break than the smaller sizes.

6. Milling cutter - Wikipedia

   en.wikipedia.org/wiki/Milling_cutter

   Milling cutters are cutting tools typically used in milling machines or machining centres to perform milling operations (and occasionally in other machine tools).They remove material by their movement within the machine (e.g., a ball nose mill) or directly from the cutter's shape (e.g., a form tool such as a hobbing cutter).

7. Burr (cutter) - Wikipedia

   en.wikipedia.org/wiki/Burr_(cutter)

   The cutters depicted in the image, being made of tungsten carbide, can withstand and operate at these elevated speeds. This allows them to function at higher velocities compared to equivalent "HSS" ( High-Speed Steel ) cutters, all the while retaining the sharpness of their cutting edges.