Ads
related to: how to calculate driveshaft length of car tires
Search results
Results from the WOW.Com Content Network
Also, when turning there is lateral torque placed upon the tires which imparts a turning force that depends upon the length of the tire distances from the CM. Thus, in a car with a short wheelbase ("SWB"), the short lever arm from the CM to the rear wheel will result in a greater lateral force on the rear tire which means greater acceleration ...
The transmission and final drive for the front axle are combined into one housing alongside the engine, and a single drive shaft runs the length of the car to the rear axle. This is a favoured design where the torque is biased to the front wheels to give car-like handling, or where the maker wishes to produce both four-wheel drive and front ...
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
Powertrain of a modern automobile, comprising engine, torque converter or flywheel, transmission, drive shaft, suspension and the wheels. This specific powertrain features all-wheel drive. In a motor vehicle, the powertrain comprises the main components that generate power and deliver that power to the road surface, water, or air.
Colorized tire footprint pressure distribution. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface.It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire's tread that touches the road surface.
Unsprung mass is a consideration in the design of a vehicle's suspension and the materials chosen for its components. Beam axle suspensions, in which wheels on opposite sides are connected as a rigid unit, generally have greater unsprung mass than independent suspension systems, in which the wheels are suspended and allowed to move separately.
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
Even if the slip angle and camber angle are zero, and the road is flat, this torque will still be generated due to asymmetries in the tire's construction and the asymmetrical shape and pressure distribution of the contact patch. Typically for a production tire this torque reaches a maximum at 2–4 degrees of slip (this figure depends on many ...
Ads
related to: how to calculate driveshaft length of car tires