Search results
Results from the WOW.Com Content Network
There is also a recovery concern: a diode's current will not decrease immediately when switching from forward-biased to reverse-biased, because discharging its stored charge takes a finite amount of time (t rr or reverse recovery time). [1] In a diode OR gate, if two or more of the inputs are high and one switches to low, recovery issues will ...
A diode can be formed away from a MOSFET source/drain, for example, with an n+ implant in a p-substrate or with a p+ implant in an n-well. If the diode is connected to metal near the gate(s), it can protect the gate oxide. This can be done only on nets with violations, or on every gate (in general by putting such diodes in every library cell).
In electronics, a step recovery diode (SRD, snap-off diode or charge-storage diode or memory varactor [a]) is a semiconductor junction diode with the ability to generate extremely short pulses. It has a variety of uses in microwave (MHz to GHz range) electronics as pulse generator or parametric amplifier .
A gate turn-off thyristor (GTO) is a special type of thyristor, which is a high-power (e.g. 1200 V AC) semiconductor device. It was invented by General Electric . [ 1 ] GTOs, as opposed to normal thyristors, are fully controllable switches which can be turned on and off by their gate lead.
See also: Diode logic § Active-high OR logic gate. The wired OR connection electrically performs the Boolean logic operation of an OR gate using open emitter or similar inputs (which can be identified by the ⎏ symbol in schematics) connected to a shared output with a pull-down resistor. This gate can also be easily extended with more inputs.
Various semiconductor diodes. Left: A four-diode bridge rectifier.Next to it is a 1N4148 signal diode.On the far right is a Zener diode.In most diodes, a white or black painted band identifies the cathode into which electrons will flow when the diode is conducting.
A schottky diode can be used to minimize the switching losses caused by the reverse recovery of a regular PN diode. [11] The switching losses are proportional to the switching frequency. In a complete real-world buck converter, there is also a command circuit to regulate the output voltage or the inductor current.
The change in the amount of transiting charge divided by the change in the voltage causing it is the diffusion capacitance. The adjective "diffusion" is used because the original use of this term was for junction diodes, where the charge transport was via the diffusion mechanism. See Fick's laws of diffusion.