Search results
Results from the WOW.Com Content Network
The basic components of heat and moisture exchangers are foam, paper, or a substance which acts as a condensation and absorption surface. The material is often impregnated with hygroscopic salts such as calcium chloride, to enhance the water-retaining capacity. HMEs used for laryngectomees are mostly hygroscopic.
The collection temperature gradually increases as it is used at room temperature. After use the disposable condensation tube inside is then removed from the external metal sleeve and the sleeve is returned to the freezer. Condensate is extracted from the walls of the condensation tube using a plunger and swept into a fluid pool for analysis.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Ventilator-associated pneumonia (VAP) is a type of lung infection that occurs in people who are on mechanical ventilation breathing machines in hospitals. As such, VAP typically affects critically ill persons that are in an intensive care unit (ICU) and have been on a mechanical ventilator for at least 48 hours.
The so-called "central vacuum" was the first sub-atmospheric pressure device available. Sub-atmospheric pressure of around 100 cm of water column was historically generated at a central location in the hospital. This "central vacuum" was available throughout the entire hospital, as it was proved via a tubing system.
The development of heated humidified high flow started in 1999 with Vapotherm introducing the concept of high flow use with race horses. [2]High flow was approved by the U.S. Food and Drug Administration in the early 2000s and used as an alternative to positive airway pressure for treatment of apnea of prematurity in neonates. [3]
The compression ratio in a MVR unit does not usually exceed 1.8. At a compression ratio of 1.8, if the evaporation is performed at atmospheric pressure (0.101 MPa), the condensation pressure after compression will be 0.101 x 1.8 = 0.1818 [MPa]. At this pressure, the condensation temperature of the water vapor at the heat exchanger will be 390 K.
HFPPV — High-frequency positive pressure ventilation is rarely used anymore, having been replaced by high-frequency jet, oscillatory and percussive types of ventilation. HFPPV is delivered through the endotracheal tube using a conventional ventilator whose frequency is set near its upper limits. HFPV began to be used in selected centres in ...