enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Power supply unit (computer) - Wikipedia

    en.wikipedia.org/wiki/Power_supply_unit_(computer)

    The first IBM PC power supply unit (PSU) supplied two main voltages: +5 V and +12 V. It supplied two other voltages, −5 V and −12 V, but with limited amounts of power. Most microchips of the time operated on 5 V power. Of the 63.5 W these PSUs could deliver, most of it was on this +5 V rail.

  3. PS-ON Signal - Wikipedia

    en.wikipedia.org/wiki/PS-ON_Signal

    #PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).

  4. Cooler Master - Wikipedia

    en.wikipedia.org/wiki/Cooler_Master

    The company headquarters of Cooler Master is located in Neihu District, Taipei City, Taiwan and has a manufacturing facility in Huizhou, China. [5] To support international operations, the company also has branch offices in various continents, including United States (Fremont, California and Chino, California), the Netherlands (), Italy (), France (), Germany (), Russia (), and Brazil ().

  5. Power good signal - Wikipedia

    en.wikipedia.org/wiki/Power_good_signal

    The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).

  6. Power-on self-test - Wikipedia

    en.wikipedia.org/wiki/Power-on_self-test

    A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.

  7. PS Power and Sample Size - Wikipedia

    en.wikipedia.org/wiki/PS_Power_and_Sample_Size

    The program provides methods that are appropriate for matched and independent t-tests, [2] survival analysis, [5] matched [6] and unmatched [7] [8] studies of dichotomous events, the Mantel-Haenszel test, [9] and linear regression. [3] The program can generate graphs of the relationships between power, sample size and the detectable alternative ...

  8. Trump mocks Justin Trudeau over top official’s shocking exit ...

    www.aol.com/news/trump-mocks-justin-trudeau-top...

    Donald Trump mocked Canadian Prime Minister Justin Trudeau over his top minister’s surprise resignation — after the pair clashed on how to handle the president-elect’s looming tariffs.

  9. Power supply rejection ratio - Wikipedia

    en.wikipedia.org/wiki/Power_supply_rejection_ratio

    For amplifiers with both positive and negative power supplies (with respect to earth, as op-amps often have), the PSRR for each supply voltage may be separately specified (sometimes written: PSRR+ and PSRR−), but normally the PSRR is tested with opposite polarity signals applied to both supply rails at the same time (otherwise the common-mode ...