Search results
Results from the WOW.Com Content Network
The following diode logic gates work in both active-high or active-low logic, however the logical function they implement is different depending on what voltage level is considered active. Switching between active-high and active-low is commonly used to achieve a more efficient logic design.
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
Diode–transistor logic (DTL) was used in the IBM 608 which was the first all-transistorized computer. Early transistorized computers were implemented using discrete transistors, resistors, diodes and capacitors. The first diode–transistor logic family of integrated circuits was introduced by Signetics in 1962.
A level shifter connects one digital circuit that uses one logic level to another digital circuit that uses another logic level. Often two level shifters are used, one at each system: A line driver converts from internal logic levels to standard interface line levels; a line receiver converts from interface levels to internal voltage levels.
The same diode circuits are used, except a switch is placed in series with each diode. To read whether a switch is open or closed, the microcontroller configures one pin as an input with an internal pull-up resistor. The other pin is configured as an output and set to the low logic level.
Over 40 different logic subfamilies use this standardized part number scheme. [6] [page needed] The headings in the following table are: V cc – power-supply voltage; t pd – maximum gate delay; I OL – maximum output current at low level; I OH – maximum output current at high level; t pd, I OL, and I OH apply to most gates in a given ...
Toggle navigation World Cup 2014. Fixtures. Round of 16. June 28 Brazil 1(3) - Chile 1(2)
Diode–transistor logic improved the fan-out up to about 7, and reduced the power. Some DTL designs used two power-supplies with alternating layers of NPN and PNP transistors to increase the fan-out. Transistor–transistor logic (TTL) was a great improvement over these. In early devices, fan-out improved to 10, and later variations reliably ...