Search results
Results from the WOW.Com Content Network
OSHA 1910.212(a)(2) requires these guards to be “affixed to the machine where possible." [1] Specifics for the type and construction of the guard are determined by the proximity of the guard to the hazard, and the type of hazard. Point of Operation Guarding refers to guarding the area of the machine where the work is performed.
1 January 2007: Source: Ergonomic Guidelines for Manual Material Handling was prepared for publication by the Cal/OSHA Consultation Service, Research and Education Unit, Division of Occupational Safety and Health, California Department of Industrial Relations. Author: Published 2007 by the California Department of Industrial Relations
In the United States, Occupational Safety and Health Administration (OSHA) is the governing body which regulates workplace safety. OSHA does not have a standard which sets a maximum allowable weight that employers must follow. [19] However, manual materials handling may fall under Section 5(a) which is often referred to as the General Duty ...
1971 – OSHA passes 29 CFR 1926.550, which is the standard for cranes and derricks used in construction for the next 41 years. [3]1995 – The National Commission for the Certification of Crane Operators (NCCCO) is established by the crane and lifting industry as a nonprofit organization to develop a certification program for crane operators.
[8] Federal agencies must have a safety and health program that meets the same standards as private employers. OSHA issues “virtual fines” to federal agencies – following an inspection where violations are found, OSHA issues a press release stating the size of the fine would be if the federal agency were a private sector employer.
A cam is a rotating or sliding piece in a mechanical linkage used especially in transforming rotary motion into linear motion. [1] [2] It is often a part of a rotating wheel (e.g. an eccentric wheel) or shaft (e.g. a cylinder with an irregular shape) that strikes a lever at one or more points on its circular
A pinch point or pinch point hazard is a common class of mechanical hazard where injury or damage may be done by one or more objects moving towards each other, crushing or shearing whatever comes between them. [1] A nip point is a type of pinch point involving rotating objects, such as gears and pulleys. [2]
Process Safety Management of Highly Hazardous Chemicals is a regulation promulgated by the U.S. Occupational Safety and Health Administration (OSHA). [1] It defines and regulates a process safety management (PSM) program for plants using, storing, manufacturing, handling or carrying out on-site movement of hazardous materials above defined amount thresholds.