Search results
Results from the WOW.Com Content Network
The coilover combines a shock absorber and a spring in a single unit. A common form of automotive suspension strut in an automobile is the MacPherson strut. MacPherson struts are often purchased by the automakers in sets of four completed sub-assemblies: These can be mounted on the car bodies as part of the manufacturers' own assembly operations.
The strut will usually carry both the coil spring, on which the body is suspended, and the shock absorber, which is usually in the form of a cartridge mounted within the strut (see coilover). The strut can also have the steering arm built into the lower outer portion. The whole assembly is very simple and can be pre-assembled into a unit.
Unlike a shock absorber, a strut has a reinforced body and stem. Struts are subjected to multidirectional loads, while a shock absorber only damps vibration, only receiving a load along its axis. Struts and shock absorbers have a different way of attachment. Shock absorbers are mounted through rubber or urethane bushings to the frame and ...
Oleo strut - design used in most large aircraft, with compressed gas and hydraulic fluid - conceptually similar to automobile Hydropneumatic suspension; Scrub radius; Short long arms suspension — also known as "unequal length A arm", one of the design parameters of double wishbone suspension; Strut bar — a part to make a suspension setup ...
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...
The MacPherson strut is a common form of strut suspension. This was not the first attempt at strut suspension, but in MacPherson's original patent, the anti-roll bar forms an integral and essential part of the suspension, in addition to its usual function in controlling body roll. A strut suspension like MacPherson's requires a hinged lower ...
A mono-tube coilover is a single piston and rod assembly in a damping case in which both compression and rebound occur. A larger mono-tube shock will be able to displace more hydraulic fluid, providing a more sensitive response to small suspension movements than twin-tube shocks. A twin-tube coilover is more complex than a mono-tube assembly.