Search results
Results from the WOW.Com Content Network
For example, an advertisement that is 3 columns wide by 6 inches high takes up 18 column inches (3 columns wide multiplied by 6 inches high). To determine the cost of the advertisement, multiply the number of column inches by the newspaper's rate. So, if a newspaper charges $10 per column inch, the cost for the advertisement discussed above ...
{{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in column 3 of the following tables. These are accepted as input by {{convert}} as the second and third unnamed parameters: {{convert|100|kg|lb}} → 100 kilograms (220 lb)
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
It is defined as the pressure exerted by a column of water of 1 inch in height at defined conditions. At a temperature of 4 °C (39.2 °F) pure water has its highest density (1000 kg/m 3 ). At that temperature and assuming the standard acceleration of gravity , 1 inAq is approximately 249.082 pascals (0.0361263 psi ).
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...
[1] [2] [3] In English-language papers, it was roughly equal to 2 column inches or 100–150 words. [3] In France, Spain, and Italy, sticks generally contained only between 1 and 4 lines of text each. [2] A column was notionally equal to 10 sticks. [4] [5]