Search results
Results from the WOW.Com Content Network
liquid measure: US barrel: USbbl US bbl 31½ US gal used for liquids except for oil and beer (see the full list) 1.0 US bbl (120 L; 32 US gal; 26 imp gal) U.S.bbl U.S. bbl barrel: oilbbl bbl 42 US gal 1.0 bbl (0.16 m 3) US beer barrel: USbeerbbl (usbeerbbl) US bbl 1.0 US bbl (120 L; 31 US gal; 26 imp gal) U.S.beerbbl (usbeerbbl) U.S. bbl
The default value is off, which will show the names of the units as specified in the Manual of Style for dates and numbers (barrels, t); on will show the abbreviated names of the units (bbl, t). lk specifies whether the names of the units should be linked and can take values of either on or off .
Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
In the oil industry, one barrel (unit symbol bbl) is a unit of volume used for measuring oil defined as exactly 42 US gallons, approximately 159 liters, [10] or 35 imperial gallons. [ 10 ]
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
Oil conversion factor from m³ to bbl (or stb) is 6.28981100 Gas conversion factor from standard m³ to scf is 35.314666721 Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
There are two codes used with fuel efficiency units: volume/length and length/volume. In addition, certain codes are required to indicate that the conversion procedure for the unit is built-in to the module. Any other text is used as an offset in the conversion calculation that occurs with temperature units.